MeridianTM-400™User’s GuideMotorized Turntablefor Rotational ObjectPhotography
Page - 10The eMCee software controls Kaidan hardware via a serial interface and inorder for eMCee to function properly it must be able to gain solitar
Page - 11EMCEE WAS WORKING THE LAST TIME I USED IT, BUT NOW THE CONTROLLER IS NOT RESPONDING?If you have been using eMCee succesfully but are now havi
Page - 1236" Turntable18" TurntableFlat Washer (8)Wing Nut (4)IN ORDER TO USE THE 36" TURNTABLE, IT MUST BE BOLTED TO THE 18" TURN
Copyright InformationCopyright © 2000 Kaidan, Inc. All Rights Reserved. First Edition, September2000. KiWi is a trademark of Kaidan, Inc. Other produc
Page - 3Chapter 1Assembling the TM-400STEP A: UNPACKING THE BOXESThe components are detailed below. Please make sure that all parts are included. Exam
Page - 4TM-400 Hardware ListHardware Package Qty.99-1069 1/2-13 Jam Nuts 8.0099-1070 1/2 Split Lock Washers
Page - 5Chapter 1STEP B:IDENTIFYING THE MERIDIAN TM-400 COMPONENTS.PLEASE REFER TO PAC KIN G LIST FOR ITEM NUMBERS
Page - 6Chapter 1STEP C: ATTACHING THE SIDE SUPPORTS TO THE BASEThe side supports (Item #2) will accept the four industrial glides, two on each side.
Page - 7STEP E: ATTACHING PEDESTAL / TURNTABLESThe pedestal and turntable assemblies for your Meridian TM-400 all use the same mounting system. Theadj
Page - 8Kaidan Warranty and Return PolicyLimited WarrantyIn the event of a defect in materials or workmanship, Kaidan will repair the product with new
Page - 9A Appendix A:Troubleshooting eMCee™THE EMCEE SOFTWARE DOES NOT RECOGNIZE THE CONTROLLER?The error message that the controller is not respondi
Comments to this Manuals